anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
•
18 Volt (or higher) drill
•
T30 Torx Bit
Assembly Instructions
Recycled
RCPSC6 -
Recycled Plastic 6' Traditional Bench
BENCH COMPONENTS:
ASSEMBLY HARDWARE:
(8) 2" X 4" Planks
(3) Bench Supports
ASSEMBLY:
Inspect the shipping container contents for damage and to determine
that all components and hardware are present.
1.
2.
Lay all parts on a soft work surface or on the shipping packaging to
prevent damage to finish.
3.
Locate one of the 2” x 4” planks and position the plank over the
innermost sets of predrilled holes in the bench supports. Mount
the 2" X 4" plank to the bench support by driving three of the
1/4" X 3" torx washer head screws with the 18 volt drill and the
T30 torx bit into the clearance holes of the planks and the pilot
holes of the bench supports.
NOTE: When installing the screws start from one end of the
bench and finish on the opposite end.
4.
Align the clearance holes in another plank with the uppermost
pair of pilot holes in the bench supports and install three 1/4" X
3" torx washer head screws.
5.
Align the clearance holes in another plank with the front pair of
pilot holes in the bench supports and install three 1/4" X 3" torx
washer head screws.
1
Recycled Plastic 6' Traditional Bench
(24) 1/4" X 3" Torx Washer Head Screws
1/4" X 3" Torx
Washer Head Screw
1/4" X 3" Torx
Washer Head Screw
2" X 4" Plank
Bench Support
Install the screws
in this direction
The assembly is a two-person operation.
