4
8/19/2014 Copyright 2014 ANOVA
®
Made in U.S.A
8.
Attach a seat support unit to the bottom of each leg using two #9 x 3” Torx screws through the predrilled holes.
Note: When attaching the half seat support units, make sure the seat leg is oriented to be nearer the full seat support unit.
9.
Turn the table right side up. It is best to use at least three
people to turn the table. Be careful when turning the table
that the seat support units land flat and don’t get twisted
or rolled. Attach the seats to the seat support units. Install
#9 x 3” Torx screws in the predrilled pilot holes on the
outside of each seat and through the seat into the seat leg.
Note: The two short seats must be attached over the full
size seat base and the two long seats attach over the two
half seat bases.
Then align the inside edges of the seats together over the
cross brace and install the inside pairs of #9 x 3” Torx
screws through each seat into the cross brace.
10.
Attach the gussets using two #9 x 2 1/2” Torx screws in
each gusset as shown.
Drive the bottom screws through the gusset and into the
seat base first. When inserting the side screws into the
gusset and seat leg, be sure to hold the leg vertical.
Note: Table is Federally ADA-compliant.
