Page 26 of 36
13.5 Cleaning the Roller Brush
Before each use, check the Roller Brush for damage, wear and tear, or
whether it has any foreign objects stuck in it.
To Remove the Roller Brush:
•
Ensure the Robot is switched off. The switch on the side of the Robot
must be in the “O” Off Position.
•
Remove the Dust Canister.
•
Gently turn the Robot upside down to access the Roller Brush.
•
Unclip the two tabs on the back of the Roller Brush Surround and
swing open, then pull out.
•
Remove the roller brush from robot by grasping the left side of the
brush and lift up, then slide out to the right.
•
Use the pick end of the small brush, (located in the top of the charging
dock), to help cut away any debris on the brush strips.
NOTE:
To avoid build-up of hair and debris around the roller brush,
clean the roller brush regularly.
Scissors may also be used to remove hair and thread etc. from the
roller brush.
Содержание MT-600
Страница 2: ...Page 2 of 36 ...
Страница 36: ...Page 36 of 36 ...
