D R T
5 7
DRT
CONNECTING THE DRT WIMAX 4301A+
SCANNER
♦
Note! The DRT 4301A+ scanner does NOT have an On/OFF switch. The unit is powered by
connecting the power cable and powered off by disconnecting the power cable. When
connecting cables to the unit, the power cable should be the last one connected and the
first one disconnected.
1. Insert one end of the RJ-45 cable in the DATA jack in the scanner, and connect the other
end with the PC.
2. Insert the power cable in the connector marked DC IN.
3. Plug the antenna cable in the FR IN B port in your DRT scanner.
♦
Note that you can only select one of the antennas, 2300/2500MHz or the 3500MHz
antenna, and connect it with the scanner. You must select between the antennas at this
point.
4. Connect the scanner’s GPS antenna cable to the scanner’s GPS port, and place the GPS
antenna on a visible spot.
5. Go to
Start
|
Control Panel
|
Network Connections
on your PC.
6. Right-click on
Local Area Connection
and select
Properties
.
7. In the
Local Area Connection Properties
dialog, select
Internet Protocol (TCP/IP)
|
Properties
.
Содержание NEMO FSR1
Страница 1: ...Version 6 20 SCANNER GUIDE...