Anita Garudan GPS/G-3525 Series, Руководство пользователя и каталог запасных частей

Страница: 24 / 87

ANITA ©
MP00800EN_161116 24
14. SENSORS FOR INITIAL POSITION OF X, Y AND Z AXIS
Default setting for initial position of X and Y axis initial point and position of Z axis (needle) is
set in the p r oduction plant .
A. Sensors are placed on the machine arm, under left cover of the linear railway (fig . 43) .
B. X axis movement position can be set by moving sensor plate ( 2) against the sensor (1 )
C. X axis movement position can be set by moving sensor plate (3) against the sensor (4)
For setting of initial points on X and Y axes move the feeding plate to its central position in
both axes. Initial point refers to the actual center position of the feeding plate towards the
needle. In this position the edges of sensor plates 2 and 4 are in line with the middle of
sensors 1 and 3 (like the edge of sensor plate on fig. 44)
D. Sensor of Z axis is located in the machine head and it can be reached after taking off
cover of the machine head . Revolving sensor plate 5 is located on the main shaft. Put
the needle in the lower stop position and make the eitting of the sensor plate 5 located
on the ring as is illustrated on the figure 44 – the sensor plate is in the middle of the
body of the sensor 6.
Clearance between sensor and sensor plate should be set for the value 0.3 - 0,5 mm.
Fig . 43
www.garudan.cz