WordClock-4 Assembly Guide 05/15/21 Version 0.8
Page 5
Step 2 – Final Assembly
•
Carefully install the tubes, and reinstall the power supplies.
Make absolutely sure that
the ENABLE jumper has been removed.
•
Install the microcontroller board, correctly orienting the USB connector and antenna, with
the markings on the board. Install the SD Card.
•
Install six, 10mm standoffs into the holes on the bottom of the main board, using six
screws (or 8 for the 8-tube version)
This completes WordClock-4 assembly. Refer to the User Manual for setup and operation
instructions.