- 20 -
C1
39
60
36
00
_1
.fm
IT
AUS
DE
FR
ES
To carry out this operation, proceed as follows.
1- Access the pilot light through the opening provid-
ed in the bottom of the appliance.
2 - Unscrew the cap (
B
).
3 - Remove the nozzle (
C
) and replace it with the one
suitable for the type of gas in use (see table at
back of manual).
4 - Replace the cap (
B
).
To carry out this operation, proceed as follows.
1- Turn off the gas supply tap.
2 - Undo the screws (
A
) and remove the control
panel (
B
).
3 - Undo the screws (
C
) to remove the support
(
D
).
4 - Unscrew and remove the burner nozzle (
E
).
5 - Replace the bushing (
F
) with the one suitable for
the type of gas in use as shown in the table.
N.B.: when replacing the bushing, screw it in until it is
resting against the burner intake hole.
6 - Replace the nozzle, (
E
), the support (
D
) and the
control panel (
B
) when the operation is complete.
Important
This operation must be carried out by
skilled operatives in compliance with the le-
gal requirements with regard to safety at
work. Never dump non-biodegradable ma-
terials, lubricating oils and non-metallic
components (rubber, PVC, resins, etc.) in
the environment. Dispose of them in ac-
cordance with the relevant legal require-
ments.
REPLACING OVEN BURNER PILOT LIGHT NOZZLE
REPLACING OVEN BURNER AIR BUSHING
GAS family
Air bushing
Natural Gas
ø30 - 9 holes
Universal LPG
ø30 - 9 holes
DECOMMISSIONING THE APPLIANCE
B
A
IDM-39603618600.tif
D
E
C
F
B
C
IDM-39603618500.tif