C1
39
60
36
00
_1
.fm
- 17 -
IT
AUS
DE
FR
ES
Important
This adjustment is only required if the type
of gas to be connected is different from that
used for testing after the conversion proce-
dure has been carried out (see page 13).
Before making this adjustment, check that
the gas supply pressure is the same as the
rated pressure for the type of gas in use
(see table at back of manual).
To carry out this operation,
proceed as follows.
1- Turn off the gas supply
tap.
2 - Pull off the knobs (
A
).
3 - Undo the screws (
B
) and
remove the control pan-
el (
C
).
4 - Remove the injector (
D
)
and replace it with the
one suitable for the type
of gas in use (see table at
back of manual).
N.B.: after making the set-
ting, seal the screw with paint.
5 - Replace the control panel (
C
) and the knobs (
A
)
on completion of the operation.
ADJUSTING OVEN GAS CONTROL VALVE MINIMUM SETTING
IDM-39603618000.tif
A
C
B
D