background image

6. TROUBLE SHOOTING

(a) Pump does not operate when solar panel is in full sunlight.

Check:

All Wiring and connections from pump to the solar panel.

Check:

If Impeller is blocked with debris, clean the pump as 

described in previous section.

(b) Pump does operate but water flow is very weak.

Check: 

Low water level causing air in tubing. Fill with water and 

restart system.

(c) Operating time is shorter than preset time.
Not enough electricity stored in the batteries. Charge properly.

7. TECHNICAL DATA

Item Number

P006B

Solar panel

1.2W – 7V

Pump Operation Voltage

DC 4.5V – 6.5V

Maximum Water lift

0.5 meter

Maximum Flow Rate

150 L/H

LED light Operation Voltage

DC 6V

WARRANTY

—

Pump is covered by a one year limited warranty

—

Solar Panel is covered by a one year limited warranty.

—

Batteries are covered for 90 days.

For more information on our solar items, please visit our web site:

www.angelodecor.com

To contact us regarding this unit, your options include:
Email: 

[email protected]

Phone: 780 – 453 6646
Fax:      780 – 453 6620

SOLAR / HYBRID FOUNTAIN PUMP USERS MANUAL

Please see our website 

angelodecor.com

for video version of assembly and use

1.

BEFORE YOU BEGIN – ASSEMBLY

¾

Unpack all components 

carefully.

¾

Install the 4 batteries (supplied), in proper orientation (+/-), in the 
housing at rear of solar panel using the small screwdriver (supplied)

¾

TIGHTEN BATTERY COVER SECURELY FOR PROPER SEAL

¾

Fully charge the unit

direct sunlight (minimum 8 hours

¾

2.

PREPARATION FOR USE

¾

Connect the pump cable to the correct socket of the housing 
on the rear side of the solar panel.

¾

Connect the tubing to the pump and
input on the solar panel as shown.

¾

Adjust flow control on pump to desired strength.

¾

Install assembled unit into the fountain, 
ensuring the pump sits at bottom of water reservoir.

¾

Fill fountain water reservoir area to capacity, 
ensuring the pump is completely submersed in water.

Содержание P006B

Страница 1: ...ATTERY COVER SECURELY FOR PROPER SEAL Fully charge the unit direct sunlight minimum 8 hours 2 PREPARATION FOR USE Connect the pump cable to the correct socket of the housing on the rear side of the solar panel Connect the tubing to the pump and input on the solar panel as shown Adjust flow control on pump to desired strength Install assembled unit into the fountain ensuring the pump sits at bottom...

Страница 2: ...off switch until the LED lights flash You will then notice the water flow vary increasing then lowering as you continue to hold the magnet in place Remove the magnet when desired flow is achieved A lower flow rate will increase the ability to reach full four hour run time The memory function records this flow rate operating the unit at this setting when restarting it at the daily time The LED ligh...

Страница 3: ...ARNINGS DO NOT TRY TO REMOVE THE IMPELLER Any alteration of the product or the components will void warranty Do not connect the pump directly to any AC voltage power it is intended ONLY for DC Voltage power The Hybrid Charging Cable is intended for INDOOR USE ONLY Operate in freshwater only never above 50 Keep away from flammable liquids Do not strike the solar panel Do not let the pump run dry 5 ...

Страница 4: ...t time Not enough electricity stored in the batteries Charge properly 7 TECHNICAL DATA Item Number P006B Solar panel 1 2W 7V Pump Operation Voltage DC 4 5V 6 5V Maximum Water lift 0 5 meter Maximum Flow Rate 150 L H LED light Operation Voltage DC 6V WARRANTY Pump is covered by a one year limited warranty Solar Panel is covered by a one year limited warranty Batteries are covered for 90 days For mo...

Отзывы: