Emelia Fountain
AD91017
Two
People
,
following these instructions
will make your assembly experience
Easy
!
Additionally, a
video
of this item assembled and running is
available on our web site
.
If you have any issues with this item, Please
DO NOT
return the unit to place of purchase.
Please visit our web site
www.angelodecor.com
for assistance and warranty information.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Printed in China
Our Thanks
Again!
Carefully unpack all parts.
Rinse non-electrical parts
with clean water.
Déballez soigneusement
toutes les pièces. Rincer
les parties non
Hold the top close and pass pump and light cords down the cord pipe. Leave
about 4 inches of slack for each. With all cords through the bowl, securely attach
them to the "3 to 1 connector". A tight seal will ensure proper light operation!
With the help of another person, carefully lift the bowl
and top over the pedestal. Align the bowl to the
pedestal. Check for obstructions then lower in place.
Turn clockwise to lock.
Pass the cord from the connector and the pump cord
down the pedestal and out the base. Align the cords
with the groove in the base of the pedestal. Securely
attach the cord from the light to the transformer.
Faites passer le cordon du connecteur et le câble de la
pompe sur le piédestal et la base. Aligner chacun des
fils avec la rainure de la base du piédestal. Fixez
solidement le cordon de la lumière au transformateur.
Attach the pump to the tubing.
The light cords should all have a
"drip loop". Install cord pipe cap.
Align and lower the top on to the
bowl.
Check the lights to
ensure they are secured
properly.
We recommend testing
the operation of the
lights before adding
water.
