Clearwater Fountain
AD97023
We hope you will find these instructions helpful in setting up your product.
If you have any issues with this item, DO NOT return the unit to place of purchase.
Please visit our web site
www.angelodecor.com
for assistance and warranty information.
Connect the pump to the
tubing.
Arrange all the parts in
your work area.
Adjust the flow control as
needed.
Pass the power cord down
the hole (shown above)
and out the base.
Align and install the top
on to the fountain.
The tubing should pass in to the hole shown above
left and then in to the reservoir area as shown above
right.
Align the cord with the
groove at the base.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
Product must be properly stored for winter.
Place the pump inside the
reservoir as shown.
Connect the pump to the
tubing.
Arrange all the parts in
your work area.
Adjust the flow control as
needed.
Pass the power cord down
the hole (shown above)
and out the base.
Align and install the top
on to the fountain.
The tubing should pass in to the hole shown above
left and then in to the reservoir area as shown above
right.
Place the decorative
pump cover over the
pump.
Hang the bucket from the
hook.
The included rope can
wrapped around the bucket
handle and top for a
personalized appearance.
Place the bird on the fountain
as shown.
Align the cord with the
groove at the base.
The final assembly should look
like this
