Installation Guide
Angel Armor Ballistic Door Panel (Level IIIA) for Chevy® Tahoe PPV
970 235 2961 [email protected] angelarmor.com
9
Detaching the Interior Door Panel and
Replacing the Window Regulator Bolt
CONTINUED
9
Lean open the door trim panel by partially
inserting the two plastic pins at the bottom
of the door trim panel into their retaining
holes in the door.
10
Peel back the moisture barrier to expose
the window regulator bolt.
NOTES:
Avoid damaging the moisture barrier.
The black adhesive on the back of
the moisture barrier is used to
re-attach the moisture barrier after
the replacement of the window
regulator bolt.
11
Remove the factory-installed window
regulator bolt.
NOTE:
Use magnetic tools to avoid
dropping the bolt inside the door.
12
Replace the factory-installed bolt with
the replacement bolt included in the
installation kit. Install the replacement bolt
in compliance with the vehicle’s factory-
recommended torque specification.
Figure 10. Replacing the 10 mm factory-installed
window regulator bolt with the supplied shorter 10 mm
replacement bolt
Figure 9. Leaning open the interior door trim panel
