Installation Guide
Angel Armor Ballistic Door Panel (Level IIIA) for Chevy® Tahoe PPV
970 235 2961 [email protected] angelarmor.com
14
Removal or
Decommission
This section describes the
process for removing the
ballistic door panel for
decommission or transfer to
another vehicle.
NOTE:
Removal is performed entirely
through the window frame. There is no need
for any interior door panel disassembly. If
the ballistic door panel has been properly
installed, the window regulator replacement
bolt supplied by Angel Armor may remain
in the vehicle with no effect on window
performance.
1
Lower the window glass completely.
2
Disconnect the vehicle battery to
prevent accidental airbag deployment.
3
Lift up on the outer window weatherstrip to
remove it from the door.
4
Grip the nylon fold at the top edge of the
ballistic door panel.
5
Slide the ballistic panel toward the back of
the vehicle, and then up, to remove it from
the vehicle door.
NOTE:
Avoid tearing the ballistic panel’s
weatherproof cover on the ‘teeth’ inside of
door by pushing the ballistic panel toward
the interior of the vehicle before it lifting out
of the door.
6
Replace the outer window weatherstrip by
placing it in position and pressing down firmly.
7
Re-connect the vehicle battery.
8
If removing the ballistic panel for transfer
to another vehicle, inspect it after removal.
Contact Angel Armor with any concerns
about wear or damage.
