Installation Guide
Angel Armor Ballistic Door Panel (Level IIIA) for Chevy® Tahoe PPV
970 235 2961 [email protected] angelarmor.com
12
Inserting the Ballistic Door Panel
CONTINUED
13
Verify that the ballistic panel is properly
positioned by confirming the following:
The airbag sensor is visible behind the
back edge of the ballistic panel.
The nylon fold at the top of the ballistic
panel aligns with and folds over the
top edge of the window frame, and the
front edge of the nylon aligns with the
vertical edge of the window frame.
NOTE:
If the ballistic door panel is not
properly positioned, remove it from the
door and repeat steps 1 through 13 of this
section. Avoid tearing the ballistic panel’s
weatherproof cover on the ‘teeth’ inside of
door by pushing the ballistic panel toward
the interior of the vehicle before lifting it
out of the door.
14
Replace the outer window weatherstrip by
placing it in position and pressing down
firmly, making sure to maintain the panel’s
proper positioning in the process.
15
Verify that no nylon is exposed below or
around the window weatherstrip.
Figure 16. Exterior view of properly installed ballistic panel
Figure 15. Proper alignment of fold with window frame
Figure 14. Ballistic door panel properly positioned forward of
airbag sensor*
* For informational purposes, the door interior is shown here with the
interior door trim panel removed completely.
Back Edge of
Ballistic Door
Panel
Airbag Sensor
