Andrisoft wanguard 6.2, Руководство пользователя

Страница: 101 / 131

Wanguard 6.2 User Guide Reports » IP Addresses & Groups
selected IP block or group. Selecting this option also enables the option below.
●
Use Per-IP Data – Creates a traffic accounting report by aggregating the IP accounting data generated for
every IP address contained in the selected IP block or group. This option will increase the load of the
server if used frequently on large subnets. Use this option carefully, only when the selected IP block or
group is not explicitly defined in the IP Zone but it is included in a larger subnet defined with the IP
Accounting parameter set to “Yes”.
The number of decoders can be modified in Configuration » General Settings » Graphs & Storage (see page
20).
Flow Records
This sub-tab is visible only when there is at least one Flow Sensor in use.
You can list and filter the flow data collected by the selected Flow Sensors, for the selected IP block, host or
group. The options are described in the “Flow Collectors” chapter on page 82.
Flow Tops
This sub-tab is visible only when there is at least one Flow Sensor in use.
You can generate tops from the flow data collected by Flow Sensors, for the selected IP block, host or group.
The options are described in the “Flow Collectors” chapter on page 82.
Profile Graphs
This sub-tab allows you to view traffic profiling graphs generated for the selected IP block or host.
Traffic profiling can be globally disabled from Configuration » General Settings » Anomaly Detection (see
page 23). Sensor generates traffic profiling graphs only for IP blocks or hosts that have the Profiling Data parameter
in the IP Zone set to “For Subnet”, “For IPs” or “For All”.
Anomaly Overview
This sub-tab generates a report with trends and summarizations of traffic anomalies sent or received by the
selected IP address, block or group.
- 101 -