Anderson SMARTMIX A1230FD, Руководство оператора

Страница: 95 / 129

Anderson Group Mixer – Operator's Manual 93
After emptying the machine, check the indexation
of the mixing augers (their positions in relation to
each other). The front auger scraper (see Figure
46 - C) and rear auger scraper (see Figure 46 - D)
must be offset from each other by 90°.
To synchronize the mixing augers:
1. Disconnect the drive shaft from the rear auger.
2. Using the tractor PTO, rotate the front auger into Position C and the rear auger into Position D.
3. Once the augers are synchronized, reconnect the drive shaft to the rear auger.
Figure 46 — Synchronizing the Mixing Augers (Two Augers)
6.3.3 A950 and A1230 SMARTMIX
Triple-auger SMARTMIX mixers have three yokes. The first yoke is located on the secondary drive
shaft and protects the three planetary gearboxes for the mixing augers (see Figure 47-A). The
second yoke is located after the first gearbox for the middle auger (see Figure 47-B). The third yoke
is located after the second gearbox for the rear auger (see Figure 47-C).
If the shear bolt for the front auger breaks (see Figure 47-A):
1. Disengage the PTO, turn off the tractor and uncouple the drive shaft.
2. Remove the piece of shear bolt from the yoke (see Figure 47-A).
3. Insert a new bolt (available on the spare bolt support) (Figure 48).
4. Put the drive shaft back in place.
If the shear bolt for the middle auger breaks (see Figure 47-B):