Anderson RBMPRO, Руководство по диагностике

Страница: 16 / 50

Computer issues (black or
flashing screen/red light
indicator is lit)
Bale carrier
Diagnostic procedure
The screen turns off (black or
flashing) and then back on again
going back to the main menu
The power supplied to the
Danfoss controller is too low.
Make sure the top right corner of
the controller screen shows a
minimum voltage of 12V. Below
that voltage, when engaging any
coil, the voltage will drop below a
critical point where the computer
loses communication, creating
this kind of issue
I have an error message
appearing on the controller
screen, and a red light indicator
is blinking on the controller
screen. Follow the prompts
from the computer. It will
show you where the fault is. If
needed replace the sensor in
question.
16