Anderson RBM1400, Руководство оператора

Страница: 84 / 95

84 Operator's Manual – Self-Loading Bale Carrier Anderson Group
5. Loosen the castle nut until there is no more friction between the castle nut and outer bearing.
Make sure that the hole for the cotter pin or hair pin clip corresponds to the notch in the
nearest nut.
6. Tap the hub with a mallet to make sure the assembly is seated.
7. Check that the hub rotates freely. It is better that it be slightly loose than too tight. If needed,
repeat steps 4 and 5.
8. Once it has been adjusted properly, insert a new cotter pin or the hair pin clip, as appropriate.
9. Put the hubcap back on.
10. Put the wheel back on (see "Assembling and attaching the wheels" on page 81 and
"Tightening the lug nuts" on page 81).
Once the wheel is back on, turn it slightly. The wheel should come to rest with a slight rocking
movement.
Figure 45 — Wheel Bearing