Anderson RB-200, Руководство пользователя

Страница: 14 / 30

14 User Guide – Round Bale Wrapper RB-200 Anderson Group
3.4 Adjusting the tilting table
1. Remove the cotter pin and rod from the from the
movable parts shown in Figure 9.
Figure 9 — Movable Parts
2. Adjust the height of the tilting table as compared to
the base of the wrapper by screwing in or
unscrewing the tractor's upper hydraulic arm
(Figure 10).
Figure 10 — Tractor's Upper Hydraulic Arm
The tilting table must not
touch the base of the wrapper.
There must be a gap between
the two movable parts when
they are unsecured and the
tilting
table is adjusted
properly.
It is correctly adjusted if the plastic film runs freely
above the plastic cutter blade when the table turns
during wrapping (Figure 11).
Figure 11 — Plastic Cutter
3.5 Attaching the hydraulic couplings
Attach the two (2) hydraulic couplings to the tractor (Figure
12).
Figure 12 — Hydraulic Couplings
3.6 Installing the film roll
To install the film roll:
1. Push the end of the upper support upward to
compress the support's spring (Figure 13).
Remove the empty roll, if necessary.