Anderson NWS-660, Руководство оператора

Страница: 59 / 120

57
12.2 Reassembly Instructions for Revolving Hoop
You have received your machine assembled in the factory according to the illustration below
(
Erreur ! Source du renvoi introuvable. ) and you want to reinstall the hoop in normal
position. Here are the steps to follow:
1 – Go inside the frame of the machine underneath the hoop and take apart the 2 spikes by
unscrewing the hex screws on the inside of the 2 spike supports. You will need a ¾" hex key.
2 – Remaining in the same place, use a ¾" hex key to unscrew and remove the 2 bolts on the
2 sides of the chassis.
3 – Also remove the ½" bolts, which are located just above the hoop pivots on each side of the
machine.
4 – Raise the hoop to vertical position and place it correctly on the small tire of the drive wheel,
pushing the drive wheel downward if necessary.
5 – Go back inside the frame to reinstall the 2 bolts on each side of the chassis. Reinstall the
spikes. Screw back in the retaining hex screws. Also put the 2 ½" screws back in the holes
above the hoop pivots. Tighten securely.
6 – Raise the hoop’s 2 security screens, which are lying on the front of the machine. The left
security screen must be permanently bolted to the left post of the hoop. The right screen has a
handle that allows it to be opened as necessary to install the plastic film rolls. Fix the handle in
place.
Figure 12.3 Revolving hoop