Anderson IFX720, Руководство оператора

Страница: 24 / 133

Anderson Group Round Bale Wrapper IFX720 – Operator's Guide 24
the film through the rollers when you start the
next bale tube.
Completely unloading the bale tube
1. Once the plastic film has been cut, activate the X-
Tractor system until all the bales have been
completely unloaded from the wrapper.
2. Retract the X-Tractor so that it returns to its home
position.
3. Back up the wrapper (see section 3.4) so that you
can close the bale tube without having to climb
up on the wrapper.
Closing the end of the bale tube by hand
Once the bale tube is complete and free of the wrapper,
close the end of the bale tube finishing bag tightly. If the
bag is sealed, the fermentation process will begin and the
bag will inflate after about 20 to 30 minutes.
If the bag does not inflate, it is not sealed. Find and repair
the leak.
Deactivating the pusher
You can deactivate the pusher if you need to change
plastic film rolls when a bale is on the pusher trigger. You
will be able to turn the hoop independently. To do this,
just turn off the ball valve located at the rear of wrapper
near the hydraulic oil tank. The pusher will then be
deactivated. See the following figure.
NOTE: Deactivating the pusher still allows you to
activate the hoop, even if a bale is on the
trigger.
Figure 22 — Deactivating the Pusher