Anderson IFX720, Руководство оператора

Страница: 34 / 133

Anderson Group Round Bale Wrapper IFX720 – Operator's Guide 34
1. Stop the engine and push the emergency stop
button and the hydraulic stop button.
2. With the bolts, slightly widen the space shown
in Figure 46. The space should be about 2.5 cm
(1 in.).
Figure 46 — Adjusting the Pusher Travel Limit
3. Start the engine and let the pusher do a complete
cycle to make sure that the problem has been
resolved.
NOTE: If the problem persists, repeat the steps to
add even more space.
Adjusting the automatic system
This adjustment can be necessary if the hoop does not
stop when the pusher comes back, or if the hoop stops but
the pusher does not come back.
To adjust the automatic system:
1. Stop the engine and push the emergency stop
button and the hydraulic stop button.
2. Pull the pusher's manual start ( Figure 47 ). Do
not start the engine.
Figure 47 — Adjusting the Automatic System
(Manual Start of the Pusher)
3. Push the manual hoop control lever to the rear of
the wrapper to completely extract the valve
spool.
4. The push the lever to the front of the wrapper
until the plate very lightly touches the end of the
slot, but without moving it (Figure 48).
Figure 48 — Adjusting the Automatic System
(Position of the Valve Spool)
5. Measure the distance between the snap ring and
the valve body. If it is 3 mm (1/8 in.) (Figure 49),