Anderson HC1 Series, Инструкция по эксплуатации

Страница: 8 / 11

P
AGE
8
CABLE SHIELD WIRE
(BARE WIRE)
SHRINK WRAPPED OR TAPED
SIGNAL SHIELD WIRE
SHRINK WRAP OR TAPE
OUTER CABLE
JACKET
INNER FOIL WRAP
CELLOPHANE WRAP
OUTER FOIL WRAP
APPROPRIATE LENGTH
FOR CONNECTION
1/8 INCH
(3 mm)
SIGNAL SHIELD WIRE
FIGURE 5-2 CE Termination Details (for CE-only applications)
5.3 CE TERMINA 5.3 CE TERMINA 5.3 CE TERMINA 5.3 CE TERMINA 5.3 CE TERMINATION PROCEDURE (FOR CE- TION PROCEDURE (FOR CE- TION PROCEDURE (FOR CE- TION PROCEDURE (FOR CE- TION PROCEDURE (FOR CE-ONL ONL ONL ONL ONLY APPLICA Y APPLICA Y APPLICA Y APPLICA Y APPLICATIONS) TIONS) TIONS) TIONS) TIONS)
CAUTION:
USE THE FOLLOWING CE TERMINATION PROCECURE WHEN THE
MEASURING INSRUMENT HAS THE EUROPEAN COMMUNITY "CE"
LABEL. IF THE INSTRUMENT IS NOT "CE CERTIFIED," USE THE
STANDARD TERMINATION PROCEDURE DESCRIBED IN SECTION 5.2
1. Refer to Figure 5-2 and carefully strip back an appropriate length of the outer cable
jacket and outer foil wrap. This exposes the signal shield wire, cable shield wire, and
cellophane-wrapped wire bundle.
2. Fold back the cable shield wire. Using shrink wrap or tape, equally cover the outer
cable jacket, and the exposed cable shield wire/cellophane-wrapped wire bundle.
3. Carefully clip back the cellophane wrap, inner foil wrap, and unused black wire up to
the end of the shrink wrap or tape applied in step 2. This exposes the signal shield
wire, and the five colored wires (red, green, yellow, white, and blue).
4. Insulate the signal shield wire with shrink wrap or tape.
5. Strip the insulation back 1/8 inch (3 mm) from each of the colored wires. Then tin each
stripped wire.
6. Using an ohmmeter or test light, verify that the signal shield wire is not shorted to the
cable shield wire. If okay, shorten the cable shield wire to an appropriate length. If not,
clip entire cable back to get a new unfinished end and start over at step 1.
7. Using shrink wrap or tape, equally overlap the existing shrink wrap or tape applied in
step 2, and the five colored wires/signal shield wire. This secures and completes the
terminated assembly.