NOVUS AUTOMATION
43/85
13.3.4
CHANNELS GENERAL PARAMETERS
NXperience
NXperience Mobile
Android
iOS
Figure 10 –
Digital Input Screen: General Configuration
•
Alarm Buzzer Runtime:
Allows you to set the buzzer runtime for each time the device enters an alarm situation. The configuration will be
performed in seconds, from 0 to 65000 s, where 0 means that the buzzer should not be triggered.
•
Mains Frequency:
Allows you to set the local power grid frequency (50 Hz or 60 Hz) for the device to perform better.
•
Intern Temperature:
Allows you to set the unit of measure in which the internal temperature will be displayed.
●
Digital Output Mode:
Allows you to configure the digital output mode, which can be configured as Disabled, Auxiliary Electronic Switch, or
Alarm Status.
o
Auxiliary Electronic Switch
: Allows you to control the power supply of external instruments during analog channel readings.
Drive Time
: Allows you to configure, in seconds, how long before each acquisition the digital output must be triggered. The minimum
configurable time is 0 seconds; the maximum time is 15 minutes (900 seconds). If equal to 0, the Auxiliary Electronic Switch will be
enabled at the exact moment of an acquisition. If greater than or equal to the lowest acquisition range, the Auxiliary Electronic Switch
will remain continuously enabled.
o
Alarm Status:
In this mode, the digital output will follow the current and general alarm status. If any channel is in an alarm situation, the
Digital Output will be enabled. If no channel is set to alarm, the Digital Output will be disabled.
13.3.5
LOG CONFIGURATION
NXperience
NXperience Mobile
Android
iOS
Figure 11 –
Log Screen
