Analytik Jena CyBio Well vario OL3381-25-300, Руководство по эксплуатации

Страница: 92 / 164

76 Release: 2017 CyBio
®
Well vario
Operation
Select the [dispense] menu item:
This will display the following box:
Fig. 71: Display - dispense
1. Move a container with dispensing stock into position under the tips (trough,
microplate).
Trigger carriage or rotary table motion, using or as necessary to
reach the required position. Raise the lifter by pressing and aspirate stock
for dispensing. Lower the lifter again by pressing .
2. Move a microplate into position under the capillary tips for dispensing.
To do this, trigger carriage or rotary table motion, using or as neces-
sary to reach the required position.
Raise the lifter by pressing , lower the lifter by pressing .
You should also note the following:
If a 96-channel capillary magazine has been inserted, a positional shift must be
included for 384-well or 1536-well processing. The same applies in the case of
1536-well processing with a 384-channel capillary magazine. If this is not the
case, continue with
→
item 4 .
Always define the type of plate to be processed in the
[Configuration] => [Wells] menu (
→
refer to page 81
→
“Wells” ).
To transfer the XY-stage into the correct position, proceed as follows:
3.
Raise
the lifter into trigger position by pressing
, lower the lifter by press-
ing
, so it will move out of the microplate wells.
Note:
With the lifter in this position, you can use or as necessary to set the
following XY-positions:
CAUTION
Prevent damage to a capillary due to faulty settings for dispensing position.
Transfer the XY-stage into the correct position for processing of 384-channel or 1536-
channel microplates.
96X capillary maga-
zine:

Motion to positions A1 to B2 for 384 well opera-
tion

Motion to positions A1 to D4 for 1536 well oper-
ation
Dispensing Pos:1
Start Exit Changing tips