Analytik Jena CyBio Well vario OL3381-25-300, Руководство по эксплуатации

Страница: 111 / 164

CyBio
®
Well vario Release: 2017 95
Operation
7. To remove the pipetting head, proceed as follows:
– Only for capillary head: Detach intermediate connector of compressed air
supply tube, do not detach connector at the head end (
→
see fig. 117 ).
– Hold pipetting head at its handle with one hand.
– Slightly raise the pipetting head.
– Carefully pull pipetting head off, using the other hand for support.
Note:
Use
recessed handle at the bottom of the magazine adapter for this purpose.
– Place pipetting head onto a stable support base.
Fig. 107: Removal of pipetting head (head replacement from the back version)
8. To insert a new pipetting head, proceed as follows:
– Hold pipetting head at its handle with one hand.
– Use the other hand to support the head.
Note:
Use
recessed handle at the bottom of the magazine adapter for this purpose.
– Hold head rails at the height as indicated by red markers, then push the pipet-
ting head in until mechanical stop position.
Only for capillary head:
– Connect compressed air supply tube for head with inlet terminal of com-
pressed air control unit.
– Check for correct setting of operating pressure at compressed air control unit.
CAUTION
There is danger of crushing or pinching! A pipetting head weighs 14 kg, a capillary head
10 kg.
Always hold the pipetting head with both hands.