Installation conditions
18
Edition 01/2014
contrAA 600
4
Installation conditions
CAUTION! ONLY SERVICE ENGINEERS ARE ALLOWED TO INSTALL
THE DEVICE!
The device may only be assembled, installed and repaired by the service engineers from
Analytik Jena AG or by technical personnel authorized by Analytik Jena AG. Any unauthor-
ized interference limits warranty entitlements.
When setting up assistance is needed for part of the time. The service engineer will test the
device and document the test in the test report of the contrAA 600.
The operator is responsible for everything (e.g., parts, guidelines) that is not included in the
original delivery, but is necessary for operation of the contrAA 600. Operation of the con-
trAA 600 demands certain local and system-specific requirements:
Suitable place for assembly
Space requirement
Environmental conditions
Supply with inert gas and additive gas
Exhaust unit
Mains connection
CAUTION! OBSERVE THE SAFETY INSTRUCTIONS!
Observe the safety instructions in chapter "Safety instructions" p.6.
Observe work protection regulations. Warnings regarding potential danger do not replace
valid work protection regulations!
Possible dangers when working with the contrAA 600 are:
Risk of burning from hot furnace parts
Danger from electric current
Danger from UV radiation
Danger of ozone or nitride oxide formation
Danger when handling pressure cylinders
Danger from toxic and chemically aggressive substances
4.1
Environmental conditions
Do not set up the contrAA 600 directly beside a door or a window. The work space of
the contrAA 600 should be free of draft, dust, corrosive vapor and also vibrations.
Do not set up the contrAA 600 close to any electromagnetic source.
Avoid direct sunlight and heater radiation on the contrAA 600. In extreme cases,
provide acclimatized conditions in the room.
