REMOTE KEYPAD FOR SMART FADE™
PAGE 8
Chapter 4 :
TECHNICAL SPECIFICATIONS
REMOTE PORT
Level:
RS 232
Data Rate:
9600 Bauds, 8 data bits, 1 stop bit, no parity bit
ENVIRONMENTAL
Power Supply:
+ 12V dc (by the SMART FADE's DB9 connector)
Temperature:
Storage : - 25°C to + 85°C
Hygrometry:
10% to 80% (without condensation)
Dimension:
W 117 x D 115 x H 55mm / W 4.6" x D 4.5" x H 2.16"
Weight:
0.5 kg / 1.1 Lbs
Chapter 5 :
WALL MOUNTING
To install the REMOTE KEYPAD in a standard 2-gang electrical box, proceed as follow :
c
Remove the front panel of the REMOTE KEYPAD (4 screws).
d
Disconnect the 5 pin screw male terminal from the REMOTE KEYPAD'S PCB and disconnect the 4 wires from the 5
pin screw terminal.
e
Connect the new cable on the 5 pin screw terminal as shown below:
PCB OF REMOTE
KEYPAD
TX
RX
OV
12V
SMART FADE
DB9 F CONNECTOR
•
Connect TX on PIN 3 of the SMART FADE's DB9 connector,
•
Connect RX on PIN 2 of the SMART FADE's DB9 connector,
•
Connect OV on PIN 5 of the SMART FADE's DB9 connector (only 1 wire is necessary),
•
Connect 12V on PIN 8 of the SMART FADE's DB9 connector.
f
Connect the 5 pin screw terminal to the PCB of the REMOTE KEYPAD and install the front panel into the standard 2-
gang electrical box.
g
Secure the front panel with the 4 screws.
