Analog way AQL-C, Руководство пользователя

Страница: 50 / 121

50 www.analogway.com
USER MANUAL
Create a Screen
In
Preconfig
> Screens / Aux Screens > Screens tab, click a Screen to show more options:
Note: An output group must be set to Screen mode to be assigned in a Screen.
- Enable/disable the Screen
- Select the Layer mode (Mixing layers or Split layers)
- Use drag and drop to assign Output groups to a Screen.
- Use to unassign an Output group.
- In
Layers
, use the
Add layer
and buttons to set the Layer quantity.
- Click Apply to save new configuration.
The number of remaining layers is indicated, it depends on layers capacity and the use of Cut & Fill .
Note: For more information about using Cut & Fill, see 14.2.3 Cut & Fill effect page 93 .
Tip: - All pending changes are identified with a * and listed in the Summary. If needed, click to cancel pending changes.
- It is possible to modify layers capacity after creation without removing all layers.
- The Optimized notifier shows when the Optimized mode is enabled. For more information see
6.4.6 Optimized mode
page 42.
Create an Aux Screen
In Preconfig > Screens / Aux Screens > Aux Screens tab, click an Aux Screen to show more options.
Note: An output must be set to Aux mode to be assigned to an Aux Screen.
- Use drag and drop to assign one Output to an Aux Screen.
The Layer quantity indicated depends on the capacity set in the Outputs tab.
- Use to unassign the Output.
Note: - After making changes, click Apply to save the new configuration.
- The number of Aux layers depends on the output capacity and the bandwidth of the content used in the layers. For more information,
see
6.3 Aux Screens and Aux layers page 38.
Tip: All pending changes are identified with a * and listed in the Summary. If needed, click to cancel pending changes.