ADSP-21375 EZ-KIT Lite Evaluation System Manual
1-5
Using ADSP-21375 EZ-KIT Lite
3. Plug the provided power supply into
J4
on the EZ-KIT Lite board.
Visually verify that the green power LED (
LED9
) is on. Also verify
that the red reset LED (
LED10
) goes on for a moment and then goes
off, and, finally,
LED1
through
LED8
are sequentially blinking.
4. Connect one end of the USB cable to an available full speed USB
port on your PC and the other end to
ZJ1
on the ADSP-21375
EZ-KIT Lite board.
Installation and Session Startup
L
For correct operation, install the software and hardware in the
order presented in the
Vi+ Installation Quick Reference
Card
.
1. Verify that the yellow USB monitor LED (
ZLED3
, located near the
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run Vi+.
2. If you are running Vi+ for the first time, navigate to the
Vi+ environment via the
Start
–>
Programs
menu. The
main window appears. Note that Vi+ does not connect to
any session. Skip the rest of this step to step 3.
If you have run Vi+ previously, the last opened session
appears on the screen. You can override the default behavior and
force Vi+ to start a new session by pressing and holding
down the
Ctrl
key while starting Vi+. Do not release the
Ctrl
key until the
Session Wizard
appears on the screen. Go to
step 4.
