Analog Devices DC2745A, Демонстрационное руководство

Страница: 1 / 10

1
DEMO MANUAL DC2745A
Rev. 0
DESCRIPTION
LTC3309A
5V, 6A Synchronous Step-Down
Silent Switcher in 2mm × 2mm LQFN
Demonstration Circuit 2745A features the LTC
®
3309A 5V,
6A synchronous step-down silent switcher operating as
a 2MHz, 3.3V to 1.2V 6A buck regulator. The LTC3309A
supports adjustable output voltages from 0.5V to V
IN
,
and operating frequencies from 1MHz up to 3MHz. The
LTC3309A is a compact, ultralow emission, high effi-
ciency, and high speed synchronous monolithic step-
down switching regulator. A minimum on-time of 22ns
enables high V
IN
to low V
OUT
conversion ratios at high
switching frequencies.
The DC2745A operating mode may be selected as
Burst Mode
®
operation, skip or forced continuous (FC)
mode. Setting JP1 to the FC/SYNC position will allow
the LTC3309A to sync to a clock frequency from 1MHz
to 3MHz. The LTC3309A operates in forced continuous
mode when syncing to an external clock.
The DC2745A is set to a fixed 2MHz frequency by con-
necting RT to V
IN
through a 0Ω resistor, R9. The frequency
can be easily changed by removing R9 and setting an
appropriate resistor in the R4 location to obtain the
desired frequency. Refer to the LTC3309A data sheet for
the proper RT value for a desired switching frequency.
All registered trademarks and trademarks are the property of their respective owners.
PERFORMANCE SUMMARY
The DC2745A also has an EMI filter to reduce conducted
EMI. This EMI filter can be included by applying the input
voltage at the V
IN
EMI terminal. The EMI performance of
the board is shown in the EMI Test Results section. The
red lines in the EMI performance graphs illustrate the
CISPR25 Class 5 peak limits for the conducted and radi-
ated emission tests.
The LTC3309A data sheet gives a complete description
of the device, operation and application information. The
data sheet must be read in conjunction with this demo
manual. The LTC3309A is assembled in a 2mm × 2mm
LQFN package with exposed pads for low thermal resis-
tance. The layout recommendations for low EMI operation
and maximum thermal performance are available in the
data sheet section Low EMI PCB Layout.
The Efficiency vs Load graph shows the efficiency and
the power loss of the circuit with a 3.3V input in Burst
Mode operation.
Design files for this circuit board are available .
Specifications are at T
A
= 25°C
SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS
V
IN
Input Voltage Range 2.25 5.5 V
V
OUT
V
OUT
Voltage Range* 1.183 1.2 1.217 V
I
OUT
OUTPUT Current 6 A
f
SW
Switching Frequency V
IN
Greater than V
OUT
1 3 MHz
t
ON
Top Switch Minimum On Time 22 ns
Duty Cycle Top Switch Duty Cycle 100 %
*With 1% resistors. Accuracy will improve to within 1% using 0.1% FB resistors.