ADSP-21992 EZ-KIT Lite Evaluation System Manual
2-8
Open
field, where D is the name of you local CD-ROM drive.
3.
Click on the
Vi+ 3.0 Installation
option.
4.
Then select
Install Tools
. This will launch the setup wizard.
5.
At the component selection screen, select the ADSP-21992 EZ-KIT Lite to install the EZ-
KIT Lite debug software.
6.
Follow this wizard with the on-screen instructions to continue installing the software.
2.4.2 Install the Vi+ License
Before the Vi+ software can be used, the license must be installed.
To install the Vi+ license:
1.
Ensure that Vi+ has been installed.
2.
Insert the Vi+ CD-ROM into the CD-ROM drive if it is not already in the
drive.
3.
Once the CD-ROM browser appears on the screen, select
Vi+ 3.0
Installation
. Then select
Install License
.
4.
Follow the setup wizard instructions. (Note: You will need the serial number located on
the back of the CD-ROM sleeve.)
2.4.3 Set up the EZ-KIT Lite Hardware
The EZ-KIT Lite evaluation board contains ESD (electrostatic
discharge) sensitive devices. Electrostatic charges readily
accumulate on the human body and equipment and can
discharge without detection. Permanent damage may occur on
devices subjected to high-energy discharges. Proper ESD
precautions are recommended to avoid performance degradation
or loss of functionality. Store used EZ-KIT Lite boards in the
protective shipping package.
The ADSP-21992 EZ-KIT Lite board is designed to run outside your personal computer as a
stand-alone unit. You do not have to open your computer case. Use the following steps to
connect the EZ-KIT Lite board:
