AMX TPI-PRO-4, Руководство по эксплуатации/справочник

Страница: 182 / 218

Using G4 Web Control®
176 TPI-PRO/DVI (Total Presentation Interface)
3.
Enter a G4 Authentication session password:
a.
Press the Web Control Password field to open the on-screen keyboard.
b.
Enter a unique alpha-numeric string, and press Done after you are finished.
This password is saved as the G4 Authentication session password, associated with VNC web access of
this TPI-PRO/DVI.
4.
Enter the port number of the Port on the TPI-PRO/DVI that the VNC Web Server is running on:
a.
Press the Web Control Port field to open the on-screen keypad.
b.
Enter a unique numeric value to be assigned to the port that the VNC Web Server is running on, and
press Done after you are finished.
The default Web Control Port is 5900 .
5.
Press the Up/Down arrows to adjust the G4 Web Control Timeout value. This value determines the
amount of time the TPI-PRO/DVI can remain idle (no cursor movements) before the VNC session is
closed and the user is disconnected.
6.
Press the Back button to open the Protected Setup page.
7.
Reboot the TPI-PRO/DVI (see the Rebooting the TPI-PRO/DVI section on page 54).
Using the NetLinx Master to Control the TPI-PRO/DVI
Before you begin:

Verify your NetLinx Master has the latest firmware (*.KIT) file loaded.

Set the Master’s IP Address via NetLinx Studio (version 2.8 or higher).
1.
Launch your web browser and enter the IP address of the target NetLinx Master into the Address field.
2.
Press the Enter key on your keyboard to begin the communication process between the Master and your
PC.

Initially, the Master Security option is disabled, therefore a Username and Password are not
required for access or configuration.

Both HTTP and HTTPS Ports are enabled by default.
3.
If the Master has been configured for secured communication, click OK to accept the AMX SSL
certificate (if SSL is enabled) and then enter a valid Username and Password into the fields in the Login
dialog.
4.
Click OK to enter the information and access the Master’s WebConsole ( Manage WebControl
Connections page).
5.
Click on Manage connections to access the Manage WebControl Connections page (FIG. 94). This page
displays links to G4 Touch Panels running the G4 Web Control feature (which was previously setup and
activated on each Touch Panel).
The remaining fields in the G4 Web Control Settings section are read-only. The name
that appears in the Web Control Name field is the device name entered in the main
Protected Setup Page (as the "Device Name") - see the Protected Setup
Page
section on page 71 .