Installation and Setup
38
Instruction Manual – HDMI-UTPRO-0808
RS-01 Adapter Cable (FG-RS01)
The adapter cable can be ordered by itself for a DCE interface with female connection.
Serial port as DCE interface with female connection:
Serial Port (RJ-12) Pinout
The following table provides the pinout configuration for the RJ-12 connector (Serial port) on the
HDMI-UTPRO-0808
and also on the HDMI-UTPRO-RX Receiver.
To connect an external serial device:
1.
Plug the RJ-12 end of the adapter cable into the Serial port on the HDMI UTPro
(or Receiver).
2.
As needed – Connect cable adapter(s) per the desired Cable Kit option on the
previous page.
3.
Plug the DB-9 end of the adapter cable (or the end cable adapter) into the serial
port on the external device.
4.
Check to be sure that the device’s serial port settings and serial port settings on the enclosure (see table to the right)
correspond to each other. If necessary, the default settings on the HDMI UTPro can be changed; see page 87.
FIG. 26
DCE interface with female connection
RX RJ-12 Pinout
Function
Abbreviation
RJ-12 Connector
Data Set Ready
DSR
Pin 1
Transmit Data
TD or TX or TXD
Pin 2
Receive Data
RD or RX or RXD
Pin 3
Signal Ground
GND
Pin 4
Signal Ground
GND
Pin 5
Data Terminal Ready
DTR
Pin 6
DB-9 Serial Port Pinouts
(female connector)
RS-232
Pin 2: TX signal
Pin 3: RX signal
Pin 5: GND
Female
HDMI UTPro
RJ-12 Port Settings
Baud Rate
9600
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
Caution:
To avoid system damage, follow the power-up sequence on page 40.
Serial Port (RJ-12) Pinout
