AMX Epica DGX 144, Инструкция по эксплуатации

Страница: 65 / 107

Epica DGX 144 DVI Boards
61 Epica DGX 144 Instruction Manual
Attaching Cables
To connect DVI inputs and outputs:
1. Fasten the DVI-I (or DVI-D) connectors on the cable ends onto the DVI-I input or output
connectors on the boards. For DVI pinout information, see page 62.
To connect DMS-59 inputs and outputs:
1.
Fasten the breakout cables onto the DMS-59 input or output connectors on the board (FIG. 32).
2. Fasten the DVI cable connectors to the breakout cables (be sure to read “Connector Numbering
Correspondence for Breakout Cable” below).
Connector Numbering Correspondence for Breakout Cable
The two DVI connectors on the DMS-59 breakout cable are labeled 1 (bottom connector) and 2 (top
connector). They route signals according to the numbering to the left of the DMS-59* receptacle:
1 corresponds to the receptacle number with the lower numerical value and 2 corresponds to the number
with the higher numerical value. For example, on the DMS-59 breakout cable for Inputs 11 and 12
(FIG. 32), the DVI connector labeled 1 routes the signal for Input 11 and the DVI connector labeled 2
routes the signal for Input 12.
* The configuration file and the internal pathways define each DMS-59 connection as two discrete signal
paths for routing.
FIG. 32
Fasten cables onto input and output connectors
DMS-59 connector
DVI-I connector
Read “Connector Numbering Correspondence
for Breakout Cable” below
(two input or output
channels each)