Enova DGX DXLink™ Fiber Boards, Duplex
112
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
In the following procedure, read each step entirely. The steps include helpful tips to avoid damage to DXLink Fiber
products.
To remove and replace an SFP+ fiber optic transceiver:
1.
If applicable – Label and disconnect fiber optic cables (release the locking tab on the cable connector to disconnect
the cable from the transceiver) or remove dust plugs from the transceiver. If cables from adjoining transceivers or
boards obstruct access, label and disconnect them as necessary.
2.
Using the tip of the index finger, swing the transceiver latch out and down (orientation of DXLink Fiber Boards
varies from system to system).
3.
Use the handle to release and carefully pull the transceiver completely free from its socket.
4.
Restore the removed transceiver’s latch to an upright position and replace the dust plug that originally shipped with
the transceiver. Place the transceiver in an ESD shielded bag and set aside.
Tip:
Leave the dust plug in the replacement transceiver for Step 5 to reduce the possibility of damaging the
transceiver / socket.
FIG. 61
Flip transceiver latch out and down (DXLink Fiber Transmitter shown)
FIG. 62
Pull transceiver free from transceiver socket
