17
6.2 Initial Display Console Set Up
Note:
The sensor array must be powered and updating before powering up
the console, or the console will timeout searching for the sensors. Perform
this step last.
Make certain the weather station sensor array is at least 3m from the
console and within 100m of the console. If the weather station is too close
or too far away, it will not receive a proper signal.
1.
Insert the power adapter into the power jack of the console, and plug in
the adapter. The LCD display will beep once and then light up. The unit
will show software version number 2 seconds after power reset.
Then the unit will turn on all segments of the LCD for 3 seconds, the unit will
start to register the outdoor channel for 3 minutes.
After initialization, the console will instantly display indoor temperature,
humidity, barometer, tendency, date and time. The wind speed, wind
direction, rain, and outdoor temperature and humidity will update on the
display within a few minutes. The remote search icon will turn on
：
