MODEL 2810E-02 USER MANUAL
2810E-02-UM
REV 2.0
15
GENERAL MAINTENANCE
4.2
The 2810E-02 chamber communicator is designed to provide years of continuous, failure-
free service when properly used and maintained. There are a few important things that the
user can do to extend the life of their equipment
1.
Handle the chamber communicator with care. If not panel mounted, do not throw it
around or drop it. Select a work area where the communicator and wires connecting to
it are out of everyone's way so it does not get knocked over.
2.
The 2810E-02 rechargeable battery should be recharged after use or as soon as
possible when the BATTERY CONDITION INDICATOR starts blinking.
4.2.1
BATTERY REPLACEMENT
1.
Remove all AC power.
2.
Turn off unit.
3.
Disconnect all cables.
4.
Remove 4 ea. pan head Phillips screws: 2 ea. on each side of "AMRON
INTERNATIONAL" & 2 ea. on each side of "MODEL 2810E-02".
5.
Lift the 2810E-02 out of chamber control panel.
6.
Remove 4ea. 8-32x1/2 pan head Phillips screws: 2ea. from both sides of
radio chassis.
7.
Tilt front panel to side of chassis.
8.
Remove 2 ea. screws from side of chassis that secures battery bracket.
9.
Disconnect the two slide terminals from battery.
10. Lift out battery.
11. Replace with new battery.
12. Connect the two slide terminals to battery, RED wire to Positive, BLACK wire
to Negative.
13. Re-install battery bracket and 2 ea. screws.
14. Permanently tighten screws.
15. Place panel on top of chassis, being careful not to pinch or damage any
wires.
16. Install 4 ea. screws on side of chassis and tighten.
17. Install communicator into cutout on chamber control panel.
18. Install and tighten 4 ea. screws to secure radio to chamber control panel.
