figure 2
figure 3
figure 4
4. Attach front panel to left side.
With the
left side panel laying on the work surface,
attach the front panel by sliding the connectors
over the steel pins. Both bottom unfinished
edges should be on the side. Use a phillips
screwdriver to tighten the 3 Quickfit-Expando 6
connectors. Turn 1/2 turn clockwise.
Do not overtighten the connectors.
Over tightening can break the connectors.
[figure 3]
5. Install bottom panel.
Place bottom panel in
the slot on the left side panel, flat unfinished
edge against the front panel. Using a phillips
screwdriver, install 4 Minibloc Screwpins through
the Minibloc holes into the predrilled holes in
the side panel. [figure 4]
6. Attach right side panel.
Place the right side
onto the front and bottom panel, tighten the 3
Quickfit-Expando 6 connectors in the front panel
and install 4 Minibloc Screwpins in the 2
Minibloc connectors on the bottom panel.
Carefully
roll unit onto front panel.
7. Install reading table and shelf.
Slide reading
table over steel pins and tighten 4 Quickfit-
Expando 6 connectors. Slide shelf over steel pins
and tighten 4 Quickfit-Expando 6 connectors.
Install 2 locking casters on the finished side of
the bottom panel and 2 non-locking casters
using the #10 x 3/4 PPH screws.
Carefully stand unit up and install sound system
using amplifier instructions.