A M P L I F I C A Z I O N I
frontal description
www
.amplificazionilombardi.it
pagina 5 di 10
There are 2 holes in the frontal panel for
the rack set up. The space of each rack
consists of 2 units.
RACK set up
The handles make it possible for the
amplifier to be put inside or taken out
from the rack.
Handles
The ventilation grill must not be covered
so that it can allow for air flow to be
released.
Ventilation grill
This potentiometer regulates the channel
volume. It is important to keep it at
minimum when turning on and off the
device.
Volume power
bridge
Power on and off switch of the device.
Power on / off switch
LAQUAD1200
Thermal protection in case the
temperature is exceeded. Plus an output
protection that activates in case of
continuous flow or short circuit.
Protection
Bridge connection between channel A
and B (and/or C and D), in this case only
the A Speakon (or C) output is possible,
and the connection is 1+2+ (do not
connect less than 4 ohm load)
crossover
Filter (each channel):
filter 1 (113 hz) filter 2 (145 hz) filter 3
(3200 hz)
high cut (green) - low cut (red)
With this led turned on the amplifier is
used correctly.
Regular output signal
1
2
3
4
5
6
8
1
2
3
4
7
9
7
8
9
5
8
6
