ISUPS2B004 Rev 1
Page 23 of 70
Ampcontrol Pty Ltd
– ABN 28 000 915 542
ISUPS 300Wh V2 USER MANUAL
ISUPS2B004 R2
– DEC/17
7
USER INTERFACE
The ISUPS is managed by using a 16 character x 2 line LCD display and a keypad.
Figure 7.1: ISUPS LCD Display and Keypad
The menus are divided into two user accessible groups: the Status Menu and the Field Configurable
Menus.
7.1 Status Menu
The status menu displays information regarding the general status of the UPS such as Output ON/OFF
and Mains ON/OFF. Other information, available from this menu by the use of the RIGHT button, ISUPS
Model, Serial Number, User Defined Label, Date and Time, Software and Hardware Version, and
Release Date.
7.2 Field Configurable Menus
The configuration menus coordinate and display changes to the settings that control the operation of the
UPS. A password is required to gain access to the configuration menus. The factory default setting for
the password is
‘0000’ (four zeros).
It is recommended that the password be changed once the UPS has been configured after installation.
Be sure to remember the password, as lost (or forgotten) passwords cannot be recovered. Creating a
new password will necessitate resetting the
password to the original factory ‘0000’ prior to creating the
new password.
CAUTION!
If the password is reset by Ampcontrol all previous user settings will be
lost and will revert to the ex-factory default. (The same as when the unit
was first delivered).
Refer to Section 10.4 for the Password Management Menu.
