For Technical Support, Contact AMP
at (775) 345-9933 (9 am - 5 pm PST)
Connect amplifier RF output SMA connector to antenna
Verify the connected transmitter’s output power is less
than the maximum input power rating (noted on HSP1
chassis) of the HSP1 power amplifier, then connect the RF
output from transmitter to RF input SMA connector.
Wire power, enable, and high/low power control (if
applicable) *see reverse side
STEP
STEP
STEP
Note
When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSP1 Power Amplifier Quick Start Guide
