For Technical Support, Contact AMP
at (775) 345-9933 (9 am - 5 pm PST)
Connect amplifier RF output SMA connector to antenna
Verify the connected transmitter’s output power is less
than the maximum input power rating (noted on HSF1
chassis) of the HSF1 power amplifier, then connect the RF
output from transmitter to RF input SMA connector.
STEP
STEP
Connect power, RF power select (if applicable), and
enable inputs to the Hirose DF13 connector *see
reverse side
STEP
Note
When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSF1 Power Amplifier Quick Start Guide
