INSTALLATION & MAINTENANCE GUIDE
–4–
w w w. a m p l i g h t i n g . c o m
–4–
Install Glare Guard and Shield to Fixture
3
Install MR16 Lamp
2
[email protected] • 813.978.3900
–5–
Install Fixture to Stake
5
AMP
®
PinnaclePro MR16 Spotlight
AAL-1017-4-B-BZ
Wire Connections
6
Insert the lamp with the correct wattage
and type as marked on the fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with bare
hands. Use soft cloth to handle lamp.
Socket
MR16 Lamp
(sold separately)
Screw the shield back onto the
fixture. Pass the glare guard over the
shield and secure with the lock screw.
Tighten until snug.
Glare Guard
Lock Screw
Shield
Fixture
Install Stake
4
Board
Stake
Soil
Ground
Determine the desired location for
mounting the fixture. Hammer the stake
into the ground until flange of stake is flush
to grade. To avoid damage to the stake,
place a board on top of the stake while
hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut in the
ground using a flat shovel.
Clear away an area in the ground
at the wireway slot on top of
the stake. Lay the luminaire
pigtail into the wireway slot and
screw the fixture onto the stake.
Tighten until snug.
Fixture
Pigtail
Wireway Slot
Stake
Strip both leads from the fixture pigtail. Using two wire connectors
(sold separately), connect the leads from the fixture to the main low
voltage supply cable lead.
Pigtail
Main Supply Cable
Wire Connectors
Install/Replace Lamp
Remove the glare guard and the shield to expose the lamp and replace
it with the correct wattage and type marked on the fixture label. Then
reinstall the shield and glare guard to the fixture.
IMPORTANT: Halogen lamps must be protected from moisture and dust at all
times. Always reinstall shield when moved.
