INSTALLATION & MAINTENANCE GUIDE
–4–
w w w. a m p l i g h t i n g . c o m
–4–
2
1
[email protected] • 813.978.3900
–5–
INSTALLATION & MAINTENANCE GUIDE
4
5
AMP
®
Deck-DesignPro Classic
ADL-2010-4-B-XX
AMP
®
Deck-DesignPro Classic
ADL-2010-4-B-XX
Remove Lens Assembly
Install Base
Install Bulb
Install Lens Assembly
Luminaire
Lens Assembly
Base
Rotate the lens assembly counter
clockwise until it is stops and then
lift the lens assembly straight off.
Note: The first time it may be
difficult because the luminaire has
a tight o-ring seal and a grease
sealant for moisture protection.
Base
Lock
Screw
Wall Anchor
Attach the base onto the desired
location and secure with the lock
screws.
Note: Wall anchors are required for
certain installation conditions (e.g.
Brick wall, Concrete Wall, etc.).
Mark on the wall for wall anchors
from the holes on the base.
Remove the base and drill proper
holes on the wall and then insert
the wall anchors.
3
Wire Connections
Luminaire
Wire Connector
Main Supply Cable
Pigtail
Strip both leads from the luminaire
pigtail. Using two wire connectors
(sold separately), connect the leads
from the luminaire to the main supply
cable leads.
Insert the bulb with correct wattage and
type marked on the luminaire label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with bare
hands. Use soft cloth to handle bulb.
Socket
Bulb
Push the lens assembly back onto the
base aligned with the gaps on the
base. Push hard (moisture proof fixture
requires force to get air out). Once the
lens assembly is flush with the base,
rotate the lens assembly until it stops
and locks into place.
Inner Shield
Base
Gap
Install/Replace Bulb
Rotate the lens assembly and then remove it to expose the bulb and replace
it with the correct wattage and type marked on the luminaire label. And
then reinstall the lens assembly.
IMPORTANT: Halogen bulbs must be protected from moisture and dust at all
times. Always reinstall lens assembly when moved.
