Ammann ARR 1575 Yanmar, Руководство по эксплуатации

Страница: 39 / 146

33 ARR 1575
2.3. Machine preservation and storage
2.3.1 Short-term preservation and storage
for a period of 1–2 months
• Wash and clean the entire machine carefully. Before park-
ing the machine for preservation and storage, please warm
up the engine to its operating temperature while running.
Park the machine on solid, flat surface at a safe place with
no risk of natural disaster (floods, landslides, fire, etc.) for the
machine.
• In addition:
- Repair damaged coating
- Lubricate all lubrication points
- Confirm that water fillings have been drained
- Check that the coolant has the required antifreezing
specification
- Check charging of the accumulators and recharge them
if necessary
- Place the fully charged infrared remote control in a dry
room and charge it up fully regularly every two months
at least
- Apply preservative grease over the chrome-coated sur-
faces of piston rods
- We recommend you to protect the machine against cor-
rosion by spraying the preservation agent, especially on
places with a risk of corrosion.
2.3.2. Preservation and storage for a period
longer than 2 months
• For machine shutdown, the same principles are applicable
as for the short-term preservation.
• In addition it is recommended to:
- Dismantle the accumulators, check their condition, and
store in a cool, dry room (recharge the accumulators
regularly)
- Place the fully charged infrared remote control in a dry
room and charge it up fully regularly every two months
at least
- Support the drum frame so that the shock-absorbing
system shows minimal sag
- Protect the rubber elements by coating with special pre-
servative agent.
- Blind the suction and exhaust pipe of the engine with
double PE foil and tighten it carefully with sealing tape.
- protect the headlamps, external back mirrors and other
elements of external wiring through spraying a special
agent and wrapping into PE foil
- Preserve the engine according to the manufacturer‘s
manual – place a visible mark that the engine is pre-
served.
• Always move the start / stop switch on the infrared remote
control to the stop position.
After 6 months we recommend you to inspect the condi-
tion of preservation and renew if required.
Never start the engine during the storage!
When the machine is stored under field conditions,
check that the parking place is not exposed to danger of
flooding due to floods and that there is no other type of
danger in this area (landslip etc.)!
If the infrared remote control is without light for a
long time, it is necessary to charge it up fully every two
months at least. Otherwise the accumulator can get
damaged irreversibly.
Before restoring operation of the machine, wash off the
preservation agents using high pressure stream of hot
water with common degreasers while observing the op-
eration manual and the ecological principles.
Remove the preservation film and wash the machine at
places provided with intercepting sumps to trap the rins-
ing water as well as deconserving agents.