Ammann 5953002, Руководство по эксплуатации, Страница: 119 / 194

113 ARX 36-2 T4i, ARX 40-2 T4i , ARX 45-2 T4i
h
1/4
2/4
1
3/4
9V
11V
15V
13V
588028A
3.6 Lubrication and maintenance operations
The lubrication and maintenance chart contains tasks and in-
structions that must be followed at certain intervals. If the table
contains two intervals of mandatory maintenance, e.g. every
1000 hours of operation or 1 year, always use the interval that
occurs first.
The worked hours can be determined by daily reading of the
data on the worked hours counter.
This manual includes only basic information about the engine; the other data are given in the operation and maintenance manual,
which is a part of documentation supplied together with the machine.
Observe instructions specified in the operation and maintenance manual!
Retighten removed or loosened bolts, plugs, threaded joints in the hydraulic system, etc. with the tightening torque specified in tables
in the chapter 3.6.51 unless a different value is given for the respective operation.
Carry out maintenance works with the machine placed on a flat, solid surface and secured against any spontaneous
movement, always with the engine off, the key removed from the ignition box and with the disconnected electrical
installation (unless otherwise required).
After the first 50 hours of operation of the new machine or after its general overhaul, carry out the following operations ac-
cording to Chapter:
3.6.22 Engine oil change
After the first 500 hours of operation of the new machine (or after a general overhaul), carry out the following operations:
3.6.33 Hydraulic oil change and filter replacement