Ammann 5953002, Руководство по эксплуатации

Страница: 71 / 194

65 ARX 36-2 T4i, ARX 40-2 T4i , ARX 45-2 T4i
OPERATING MANUAL
2.7.2 Drive and reverse drive
Before moving off, check that the articulation joint of the machine is locked.
Use the warning horn to signal that the engine is starting and wait long enough so that all persons could leave the area
around the machine or under the machine in time!
Before moving off, check that the area in front of and behind the machine is empty and that there are no persons or
obstructions there!
The operator must not control the machine from the ground. If he did so anyway and is not sitting on the seat when
the travel control is moved from the parking brake position (P), the machine does not disengage the brake and will not
move, and after 5 seconds the engine will be stopped.
The operator must not leave the operator seat when operating the machine. If he does so anyway and leaves the seat
when the travel control is in deflected form the parking brake position (P), the machine behaves according to the seat
switch description (Chapter 2.6).
Start the engine
• Start the engine according to Chapter 2.7.1.
• Set the maximum engine speed using the engine speed control (3).
Selection of the working engine speed:
• Set the engine speed control (3) to the working speed.
Working speed:
• 100% travel speed (depending on the transport and working speed change-over switch)
• 100% engine speed
Selection of the travel direction
• Selection of the travel direction is set on the active travel control. Set and leave the inactive travel control in the parking brake
position (P).
• Move the travel control (11) from the parking brake (P) to the neutral position (N) – releasing of the brakes, the parking brake indi-
cator lamp (30) goes out.
• Move the travel control (11) to the position (0) and select a travel direction (F/R).
When the driver releases the travel control (11), it does not return to the zero position automatically. The travel control remains in the
selected position.
When the driver quickly moves the travel control (11) through the zero position (0) from the selected direction of the machine travel,
e.g. due to a dangerous situation, the machine stops and the parking brake is engaged (panic response).
When the driver moves travel control (11) from the selected direction of machine travel to the neutral position, e.g. due
to a dangerous situation, the machine stops but the parking brake is not engaged. This may cause counting movement
of the machine when driving down the slope, due to leakages form the hydraulic system.