Ammann 5953002, Руководство по эксплуатации

Страница: 51 / 194

45 ARX 36-2 T4i, ARX 40-2 T4i , ARX 45-2 T4i
OPERATING MANUAL
Brake test button (A)
Used to check the correct brake function.
Calibration button (B)
Used to calibrate functions:
• start ramp HARD / SOFT
•
activation of the left travel lever
• infra thermometer setting °C / °F
AMN138
Beacon and rear light change-over
switch (1)
• To the gear 1: The beacon is ON.
• To the gear 2: The rear light is ON.
It is possible that the machine is equipped with a beacon but
the corresponding change-over switch is missing. In such
a case, the beacon will start in continuous operation as soon as
the ignition key is set to the position I.
AMN45
Differential lock button (2)
It is used for turning on the differential lock.
The differential lock prevents the drum from slipping when
crossing a difficult terrain.
The differential lock is used for improving surface adhesion of
the tyres, stability and controllability.
Turn the differential lock off after the difficult ground
has been overcome!
Engine speed control (3)
The control setting allows you to better adjust the speed and
the vibration power to the given soil conditions.
Idle speed: Set the control to the first position.
Small working speed: Set the control to the position I (85%).
Big working speed: Set the control to the position II (100%).
Small working speed:
Frequency I
85% vibration capacity
85% travel speed (depending on the transport and working
speed change-over switch)
85% engine speed
Big working speed:
Frequency II
100% vibration capacity
100% travel speed (depending on the transport and working
speed change-over switch)
100% engine speed
0
1
2
AMN010D
Travel mode switch (4)
Loading mode (0)
• Limited travel speed.
• Activated differential lock.
•
Blocked working functions of the machine (vibration).
Working mode (1)
• Machine working speed (7 km/h).
• Option to activate the differential lock for the time necessary.
• Option to activate the working functions of the machine
(vibration).
Transport mode (2)
• Machine transport speed (10 km/h).
• Deactivated differential lock.
• Blocked working functions of the machine (vibration).
AMN83
Sprinkling potentiometer (5)
OFF in the position “0”. Turn the sprinkling potentiometer from
the position “1” to the position “MIN” to smoothly control the
sprinkling intensity of the drums.
AMN142
STOP
ST
OP
ST
OP
Emergency brake button (6)
Pressing the button activates the emergency brake of the ma-
chine. The machine stops, the engine shuts down. After activat-
ing the emergency brake button the indicator lamps for battery
charging (22), engine lubrication (23), parking brake (29) and
emergency stop (26) are shown on the display.