Ammann 5953002, Руководство по эксплуатации

Страница: 144 / 194

138 ARX 36-2 T4i, ARX 40-2 T4i , ARX 45-2 T4i
595018
615065
x
y
3.6 Lubrication and maintenance operations
Keep the level within the range of gauge marks imprinted in the
dipstick. The lower mark shows the lowest possible oil level, the
upper mark indicates the highest.
Refill the oil to the upper oil level mark. The oil volume is 6.8 l
(1.8 gal US) including the oil filter volume.
Note
After refilling, start the engine and leave it running for 2–3 min.
Check tightness of drain plug and filter.
Stop the engine, wait for 5 minutes until the oil runs down to the
engine sump. Then check the level with the oil dipstick.
When changing oil, check that the old oil has been dra-
ined from the tank completely. Do not mix different ty-
pes of oils.
During the regeneration process, the engine oil can be diluted
by the fuel. This can lead to an increase of the amount of engine
oil. If the engine oil level rises above the top mark, change the
oil.
If the DPF regeneration interval is shorter than 5 hours, replace
the oil.
Caution! There is a risk of scalding when draining hot oil.
Let the oil cool down below 50 °C (122 °F).
Follow the fire-fighting measures.
Change the oil after 6 months at the latest even if 500
hours have not been worked. Change the oil at the inter-
val that comes first.
Use recommended filters only; refer to the spare parts
catalogue. Use recommended oils; see Chap. 3.2.1.
Catch the drained oil and do not let it soak into the
ground.
Used oil and filters are environmentally hazardous waste
– hand it over for disposal.